av色综合网站_一大片看一级大片看_亚洲日韩第三十六页_久久丁香五月丁中文精品

1.山東注塑加工確定緊急停止按制能切斷油泵部份馬達電源。Shandong injection molding process to determine the emergency stop according to the system can cut off the oil pump motor power.

2.山東注塑加工應該保持注塑機和機身四周清潔。Shandong injection molding machine should be maintained around the injection molding machine and clean.

3.檢查溫度針與發熱筒是否操作正常。Check whether the temperature needle and the heating cylinder operate properly.

4.檢查安全門拉開時能否終止鎖模。分別用手動、全半自動操作鎖模進行測試。Check whether the safety door can be stopped when the door is opened. Manual and fully automatic operation of the lock mode test.

5.山東注塑加工的工作人員應該檢查模具是否穩固安裝在鎖模頭板及移動模板上。Shandong injection molding staff should check whether the mold is firmly installed in the mold head plate and mobile template.

6.檢查各冷卻運水喉管是否有漏水現象，收緊漏水的喉管。Check the cooling water pipes are leaking phenomenon, tighten the leakage of the throat.

7.檢查所有罩板是否穩固安裝于機器上。Check that all panels are firmly installed on the machine.

8.山東注塑加工開機運行一段時間后，檢查油溫是否上升超過攝氏50度。檢查供應冷卻的冷卻運水溫度，油溫應保持30-50攝氏度。Shandong injection molding machine running after a period of time, check the oil temperature is rising more than 50 degrees celsius. Check supply cooling water temperature, oil temperature should be maintained at 30-50 degrees celsius.

9.山東注塑加工工作人員應該檢查機械安全鎖是否操作正常。Shandong injection processing staff should check whether the normal operation of mechanical safety lock.